X-ray microradiography was employed to quantify the strains in loaded human trabecula. Samples of isolated trabeculae from human proximal femur were extracted and glued in a loading machine specially designed and manufactured for testing small specimens. The samples were then tested in tension and three-point bending until complete fracture of the specimen occured. To assess the deformation in the very small samples (thickness 100μm, length 1—2mm) a real-time microradiography in conjunction with digital image correlation (DIC) has been employed. Loaded samples were irradiated continuously by X-rays (Hamamatsu L8601-01 with 5μm spot) during the test. Radiographs were acquired using 0.25s exposure time with hybrid single-photon counting silicon pixel detector Medipix2. The distance between the source and detector was kept small to ensure radiographs of good quality for such a short exposure time. Design of the experimental loading device enables for precise control of the applied displacement which is important for the post-yield behavior assessment of trabeculae. Large dynamic range, high sensitivity and high contrast of the Medipix2 enables measuring even very small strains with DIC. Tested experimental setup enables to combine micromechanical testing of the basic building block of trabecular bone with time-lapse X-ray radiography to measure the strains and to assess the mechanical properties of single human trabecula as well as to capture the softening curve with sufficient precision.